NCrunch Forum
»
General Support
»
Daily Usage Issues
»
Rider: Cannot enable NCrunch if opening a csproj file instead of sln
Rank: Advanced Member
Groups: Registered
Joined: 6/17/2012(UTC)
Posts: 507
Thanks: 145 times
Was thanked: 66 time(s) in 64 post(s)
|
[v5.3.0.2]
If I open a csproj file in Rider "Enable NCrunch" is grayed out (it works in VStudio).
IF adding the same csproj file to a solution and open the solution, "Enable NCrunch" becomes enabled.
|
|
|
|
|
|
Rank: NCrunch Developer
Groups: Registered
Joined: 9/22/2017(UTC)
Posts: 306
Location: Netherlands
Thanks: 138 times
Was thanked: 73 time(s) in 69 post(s)
|
I don't know if we can solve this under Rider. The plugin life cycle is currently tied to the solution life cycle. I'll have to look into this, I'm putting a task on our board
|
|
|
|
|
|
Rank: Advanced Member
Groups: Registered
Joined: 6/17/2012(UTC)
Posts: 507
Thanks: 145 times
Was thanked: 66 time(s) in 64 post(s)
|
Ok. FWIW, IMHO it's a minor issue. I just happened to notice it when trying out to do a repro. NCrunch even states "You can Enable NCrunch<...>while a solution is open." (in both VS/Rider though).
|
|
|
|
|
|
NCrunch Forum
»
General Support
»
Daily Usage Issues
»
Rider: Cannot enable NCrunch if opening a csproj file instead of sln
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
YAF |
YAF © 2003-2011, Yet Another Forum.NETThis page was generated in 0.018 seconds.
